an official journal of: published by:
an official journal of: published by:
Editor in Chief: RAFFAELLO COSSU


  • Lidiane Maria Andrade - Department of Chemical Engineering of the Polytechnic School, University of São Paulo , Brazil
  • Mariana Alves de Carvalho - Department of Chemical Engineering of the Polytechnic School, University of São Paulo, Brazil
  • Marcos Paulo Kohler Caldas - Federal Institute of Education, Science and Technology of Espirito Santo, Brazil
  • Denise Espinosa - Department of Chemical Engineering of the Polytechnic School, University of Sao Paulo, Brazil
  • Jorge Tenòrio - Department of Chemical Engineering of the Polytechnic School, University of São Paulo, Brazil

Released under CC BY-NC-ND

Copyright: © 2019 CISA Publisher


Over the years, the generation of Waste Electric and Electronic Equipment has been significantly increased, which leads to environmental and economic concerns. Thus, it is fundamental to develop treatment methods for these residues. Printed Circuit Boards are essential components of electronic equipments. In this sense, printed circuit boards are composed of remarkable metals, in particular, copper and silver at high and low concentrations, respectively. These metals can be recovered by the hydrometallurgical process followed by a chemical purification step. Therefore, the aim of this study was to leach silver and copper from two different printed circuit boards (memory board and motherboard) from obsolete computers by hydrometallurgical route based on only one-stage leaching in oxidant media. When compared to the motherboard, a higher recovery rate of Ag was obtained from memory boards 83% and 33%, respectively. Whereas, similar recovery rates of copper were observed for memory board and motherboard, 48% and 46%, respectively.


Editorial History

  • Received: 06 May 2019
  • Revised: 20 Oct 2020
  • Accepted: 18 Nov 2020
  • Available online: 26 Feb 2021


Bidini G., Fantozzi F., Bartocci P., D’Alessandro B., D’Amico M., Laranci P., Scozza E., Zagaroli M. (2015). Recovery of precious metals from scrap printed circuit boards through pyrolysis. J Anal Appl Pyrolysis., vol 111, 140-147

Cayumil R., Khanna R., Rajarao R., Mukherjee P. S., Sahajwalla V. (2016). Concentration of precious metals during their recovery from electronic waste. Waste Mannag., vol. 57, 121-130

Choubey, P. K., Panda, R., Jha, M. K., Lee, J., Pathak, D. D. (2015). Recovery of copper and recycling of acid from the leach liquor of discarded Printed Circuit Boards (PCBs). Sep. Purif. Technol. Vol 156, 269-275

Cui H., Anderson C. G. (2016). Literature review of hydrometallurgical recycling of printed circuit boards (PCBs). J Adv Chem Eng., vol 6, n. 1

Diaz L. A., Lister T. E., Parkman J. A., Clark G. G. (2015) Comprehensive process for the recovery of value and critical material from electronic waste. J Clean Prod., vol. 125, 236-244

Ghosh B., Ghosh M. K., Parhi P., Mukherjee P. S., Mishra B. K. (2015). Wasted Printed Circuit Boards recycling: An extensive assessment of current status. J Clean Prod., vol 94, 5-19

Gurung, M., Adhikari, B. B., Kawakita, H., Ohto, K., Inoue, K., Alam, S. (2013). Recovery of gold and silver from spent mobile phones by means of acidothiourea leaching followed by adsorption using biosorbent prepared from persimmon tannin. Hydrometallurgy, vol 133, 84–93

Ilyas S., Ruan C., Bhatti H. N., Ghauri M. A., Anwar M. A. (2010). Column bioleaching of metals from electronic Scrap. Hydrometallurgy., vol. 101, n. 3-4, 135-140

Ilyas, S., Anwar, M. A., Niazi, S. B. (2007). Bioleaching of metals from electronic scrap by moderately thermophilic acidophilic bacteria. Hydrometallurgy. vol. 88, 180-188

Kaya M. (2016). Recovery of metals and nonmetals from electronic waste by physical and chemical recycling processes. Waste Manag., vol 57, 64-90

KITCO. (2018). Live Silver Price. Available on:

Kumar A., Holuszko M., Espinosa D. C. R. (2017). E-waste: An overview on generation, collection, legislation and recycling practices. Resour Conserv Recy., vol. 122, 32-42

Kumar, V., Lee, J., Jeong, J., Jha, M. K., Kim, B., Singh, R. (2015). Recycling of printed circuit boards (PCBs) to generate enriched rare metal concentrate. J. Ind. Eng. Chem., vol 21, 805-813

LME (London Metal Exchange). 2020a. LME Copper official prices. Available on:

LME (London Metal Exchange). 2020b. LME Silver. Available on:

Neto, I. F. F., SOUSA, C. A., Brito, M. S. C. A., Futuro, A. M, Soares, H. V. M. (2016). A simple and nearly-closed cycle process for recycling copper with high purity from end life printed circuit boards. Sep. Purif. Technol., vol 164, 19-27

Official Journal of the European Union (2003a). Directive 2002/96/EC of the European Parliament and of the Council on waste electrical and electronic equipment (WEEE). Available on:

Official Journal of the European Union (2003b). Directive 2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment (RoHS). Available on:

Shokri A., Pahlevani F., Levick K., Cole I., Sahajwalla V. (2017). Synthesis of cooper-tin nanoparticles from old computer printed circuit boards. J Clean Prod., vol. 142, 2586-2592

Silvas F. P. C., Correa M. M. J., Caldas M. P. K., Moraes V. T., Espinosa D. C. R., Tenorio J. A. S. (2015). Printed circuit board recycling: physical processing and copper extraction by selective leaching. Waste Manag., vol. 46, 503-510

Xu Y., Li J., LiliLiu. (2016). Current status and future perspective of recycling copper by hydrometallurgy from waste printed circuit boards. Procedia Environ Sci., vol. 31, 162-170

Zhou Y., Qiu K. (2010). A new technology for recycling materials from waste printed circuit boards. J Hazard Mater., vol. 175, 823-828

Žiūkaitė S., Ivanauskas R., Tatariants M., Denafas G. (2017). Feasibilities for hydrometallurgical recovery of precious metals from waste printed circuit boards in Lithuania. Chemija, vol. 28, 109-116